Clipsal C-Bus Dokumentacja Pobierz pdf (Strona 15)

1A. Introduction to C-Bus

4.0 Wiring Methods

The following sections demonstrate the difference between conventional wiring and C-Bus wiring,

when installing a two-way control for four light circuits.

4.1 Conventional Wiring

Figure 5 indicates how many wires are needed to perform two-way control between two four-gang

plates. As many as 13 mains conductors need to be run between the two plates and the loads.

Figure 5 – Conventional wiring of a two-way control for four light circuits

4.2 C-Bus Wiring

Figure 6 shows how the same two-way control is wired using C-Bus (pink wiring). The control circuitry

is simpler than the conventional method. If a four or eight button switch is used instead of the two

button, the wiring remains the same. Just two conductors are required to link the C-Bus control.

Figure 6 – C-Bus wiring of a two-way control for four light circuits

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Brak uwag

Clipsal C-Bus Dokumentacja Strona 15